The Little Lamb Blanket Buddy is the BONUS SET for those who preordered this series by June 5th.  Thank you preordering this series!

New Blanket Buddies are an In The Hoop Project for the 5x7 hoop! 

They can be made with fleece or minky for a cuddly soft bedtime friend for your favorite little one!

They're totally sewn in the hoop except for one small straight seam which is sewn shut by hand.

You can use a purchased receiving blanket or hem your own square of fabric for your blanket buddy.  You must be EXTRA CAREFUL if using a fleece blanket to make certain your presser foot does not slip between the layers of fleece.  You can even sew your own blanket by hemming a simple square of flannel, minky, fleece or satin!

 This Little Lamb was made in response to numerous requests for a Lamb Blanket Buddy!

The Blanket Buddies Pictorial is listed at the bottom of this page.

$15.00. 

 To purchase the Little Lamb Blanket Buddy, please click on the paypal button for the design and format of your choice:

 Little Lamb Blanket Buddy (includes pes, jef & hus formats): 

Blanket Buddies Instructions:

The Little Lamb Blanket Buddies are made just like the bear blanket buddies.  The number of colors stitched for the faces may vary slightly.  :)  Instructions are given for the Bear Blanket Buddy.

1.  Hoop one layer of tearaway stabilizer.

2.  Sew the first color stitch (bear outline).

3.  Without unhooping, pin one piece of 5x7 fabric such as fleece or minky on top of the stabilizer covering the outline completely.  Be certain that the pins are not in the needle's path!  Stitch the second color stitch to secure fabric.

4.  Stitch the next two colors (third and fourth colors) ( (bear's muzzle, eyes, nose and mouth).

5. Stitch the fifth color (rectangle outline).  This shows the area to place the blanket.

6.  Take your blanket and fold in half into a triangle with wrong sides together.

7.  Now fold each of the sides toward the center.

8.  Center the top of the folded blanket so the top point extends past the rectangle outline on the bear.  The sides of the blanket should fit within the rectangle with approximately a 1/4" margin to spare on each side.  Carefully pin in place making certain no pins will be in the needle's path.

See picture.

9.  Sew the sixth color to secure blanket.  BE CAREFUL IN THIS STEP that your presser foot does not slip underneath the blanket.  If desired you can use a piece of tape to keep the blanket in place and simply remove it after stitching.

10.   Trim the top of the blanket right at the top of the rectange stitching outline.

See picture.

12.  Stitch the seventh color (ribbon placement outline).

13.  Place a piece of 5/8" ribbon across the bottom of the bear so the top of the ribbon is right above the ribbon placement outline.

14.  Sew the eighth color to secure ribbon.  Pin at the sides and secure along the edge with tape if desired.  Again, be careful that the presser foot does not slip under the ribbon. 

15.  Place a second 5x7" piece of fabric on top of the hooped fabric RIGHT SIDE DOWN.  Stitch the final color (bear outline).

16.  Remove the fabric from hoop.  Trim, leaving a 1/4" seam and clipping turns and corners well.

Turn right side out.  Stuff as desired with polyfil.  Stitch opening closed by hand.

You're done!