The Heart Stemware Coaster is the final design in the Dollar Days Ten Series!  Thank you to everyone who joined this series!

The Heart Stemware Coaster is made in one 4x4 hooping with no other stitching require.

Each one is very quick and easy to make.  They slip over the bottom of your footed stemware to protect your furniture.  The fabric can be used in an assortment of colors so everyone can easily identify their glass.  These coasters will fit most stemware that has an approximate 3" round footed bottom.  I tried it on all of mine and it fit all of the various styles that I have.

$8.00

Complete instructions can be found at the bottom of this page.

To purchase the Heart Stemware Coaster, please click on the add to cart button.

Heart Stemware Coaster (includes pes, jef & hus formats):

 

Heart Stemware Coaster Instructions:

1. Hoop one layer of tearaway or water soluble stabilizer.

Stitch first color (coaster fabric placement outline).

Cut and fold two pieces of 5x6" fabric so each is 5x3".  Place one piece of fabric on top portion of design so the folded edge is even with the horizontal stitching line in the center of the outline and the entire top of design is covered.

IMPORTANT:  Tape the folded edge down its entire length so the presser foot does not become entangled in it  in future steps.

Stitch the second color to secure.

2.  Stitch the third color (hearts).

3.  Place the second piece of folded fabric on bottom portion of design so the folded edge is even with the horizontal stitching line in the center of the outline and the entire bottom of design is covered.

IMPORTANT:  Tape the folded edge down its entire length so the presser foot does not become entangled in it  in future steps.

Stitch the fourth color to secure.

4.  Stitch the fifth color (hearts).

5.  Cut two 5x5" pieces of fabric.  Place one piece of fabric on top of design FACE DOWN covering completely.

Place second piece of fabric on top of design FACE UP covering completely.

Stitch final color to secure.

6. Remove from hoop.  Trim around perimeter of design leaving approximately 1/8" -1/4 seam allowance and being careful not to cut stitching.

Clip around curves for easy turning.

Remove excess stabilizer.

Turn right side out.  Slip over stemware.

You're finished!